Skip to content
Black PearlGarage · Laurel MD
Front three-quarter of a black coupe after a full detail, parked on a main street at golden hour
Detailing · Laurel, MD

Depth is built in layers.

Decontaminate, cut, refine, protect. Do all of it in one visit and the car does not just look clean. It looks corrected.

From
$150
Services
4
Time from
3 hr 45 min
The servicesby class · tap a row to open

Four details, measured in hours.

Sedan prices, 20% deposit. Tap a row for what is in it.

Every price →
How it's done

Four stages, in this order, every time.

  1. 01Foam and contact wash
  2. 02Decontamination
  3. 03Machine polish
  4. 04Protection and inspection
In full
  1. Foam and contact washA foam pre-soak lifts the loose grit off before anything touches the panel. Then a contact wash, panel by panel, with the wheels and jambs done separately.
  2. DecontaminationWhat the wash cannot remove — bonded fallout, road film, the roughness you can feel through a bag — comes off mechanically. The surface has to be perfectly clean before a pad goes near it.
  3. Machine polishThe correction step. A machine polish levels the clear coat, removing the light scratching that scatters light, until reflections run straight.
  4. Protection and inspectionThe polished surface gets protected so the work is not exposed. Then the whole car is checked under a hard light before it goes back to you.
What actually causes swirl marks?

Almost always the wash, not the road. Spinning brushes in an automatic tunnel, a dirty sponge, one bucket instead of two, or drying with a towel that has been dropped. Each one drags grit across the clear coat and leaves thousands of fine scratches. Under direct light they read as a halo.

Is this the same as paint correction?

Exterior Enhancement is a single-stage polish — it removes a meaningful share of light defects and restores gloss. The Pearl Signature Detail steps up to a two-step polish, which cuts harder before it refines. Deep scratches you can catch a fingernail in are below the clear coat and cannot be polished out by either.

4 more questions
What is a two-step polish?

The first step cuts — a more aggressive pad and compound that levels the clear coat and removes defects. The second refines that surface back to full clarity, because cutting alone leaves its own fine marring. Single-stage skips the refining pass; on dark paint you can see the difference.

Why does the Signature take nearly seven hours?

Because a two-step polish is two passes over every panel — a cutting stage and a refining stage — and neither can be rushed without leaving haze. Add the full interior, the engine bay, the wheels and jambs, and the inspection at the end, and that is the day.

What is the difference between a Refresh and a Reset?

A Refresh is maintenance — vacuumed through and wiped down, two hours, keeps a clean car clean. The Reset is restoration: the carpets and upholstery are shampooed and extracted, so what comes out is the material that has soaked in rather than the debris sitting on top. It runs four hours forty-five.

Do I get the car back the same day?

Usually yes, if it goes in first thing. Bookings are Wednesday to Sunday, and the slot is confirmed when you book so you know before you drop it off.

Book itBy appointment

Take the reflection test yourself.

Walk out to your car in daylight and look at what the hood reflects. If the lines bend, that is what this service fixes.

  1. 01Book or call
  2. 02Drop the keys at the bay
  3. 03Pick it up checked
Call

Booking request

Tell us about the car.

Step 1 of 3 · What you need

This is for
What does it need?